Home > Hollow Core Voice Coil Driven Stages

Home > Direct Drive Linear Motors and Electric Cylinders

Direct Drive Linear Motor DDLM-019-044-01
Continuous Force: 11.0 Oz (3.1 N), Stroke: 0.416 in (11.7 mm)


 

Previous Buy Online View Cart Next
Housing Outside Diameter, 0.750 inch, 19.1 mm

Direct Drive Linear Motors DDLM-019-044-01

This compact, zero cogging, clean, quiet, fully enclosed linear actuator, also referred to as an electric cylinder, is just 0.750 in. (19.1 mm) in. diameter has a housing length of 1.750 in. (44.5 mm) long and has a stroke of 0.460 in. (11.7 mm). This linear actuator can develop 11.0 oz (3.1 N) of continuous force and 34.8 oz (9.7 N) peak force. Direct coupling of the actuator to the load results in zero backlash and allows for smooth, high acceleration/deceleration, and high speed positioning.

The low cost DDLM-019-044-01 non-commutated linear actuator, can be easily integrated into new and existing applications.

The 0.125 in. (3.2 mm) diameter shaft has an internal thread on each end, a total of length of 3.460 in (87.9 mm), and extends 1.085 in. (27.6 mm) past the mounting end of the actuator.

The shaft extends thru the 3/8-32 UNF x 0.250 (6.4 mm) long threaded studs at each end of the housing which can be used for mounting the DDL-019-044-01 linear actuator. Long life plain linear bearings support the internal shaft at both end of the actuator.
Model # Stroke Continuous Force Intermittent Force @ 10% Duty Cycle Housing Length
DDLM-019-044-01 0.460 inch 11.0 oz 34.8 oz 1.750 inch
Datasheet in PDF PDF 11.7 mm 3.1 N 9.7 N 44.5 mm
Drawing quick view Mechanical Drawing
Buy Online Download 3D-STEP

Share this page: